Adjust Glass Shower Door Hinges

Frameless shower doors usually only need to be adjusted from the screws on the hinges and are usually accompanied by manufacturer instructions.

Adjust glass shower door hinges.

Then press the door back against the hinge until it is snug. Brought to you from. A door hinge that has come loose may cause the door to drag at the bottom causing damage to the door. One or two tries are usually sufficient.

If the door is still out of alignment with the frame loosen the screws and repeat the procedure. They ride along a slanted adjustment slot that will raise and or lower the wheel. A do it yourself homeowner can adjust the hinges and align the door with the help of an. Remove the shim and two by four block from beneath the door.

Re tighten all of the screws. Then hold the door closed by the handle lifting as needed while your assistant places shims at the underside of the door on top of the shower dam. While adjusting you will likely need a partner s help to prevent the glass door from falling to the ground as you loosen the door. Step 4 set the door on the wood and move it into position so that the hinges are over the holes in the wall of the shower then screw the hinges into the wall.

If you need to lower the door move the hinge down to adjust the shower door to the right height make sure you clean up any caulk or adhesive when you are moving the hinges you can apply a fresh coat of the sealer once you move the hinge. Using the appropriate allen key loosen the hex head bolts on each hinge with two 360 degree turns counterclockwise. Hinges for frameless shower doors have hex head machine bolts at the inside that secure the hinges in place. The clamps are usually tightened to the glass with phillips head screwdrivers.

Remove the screw and attach another wheel or. Open the door slightly and place wedges under it so the weight is supported. Make sure the top of this hinge is flush with the top of the door and that the entire hinge is seated against the edge of the glass before you tighten the screws. The rollers are attached to the upper shower door with a screw.

You ll commonly find hinged glass doors in bathroom showers with the hinges drilled directly into the glass or held in place with pressure alone. Generally you need to slightly loosen the screws and allow for swing by placing a shim beneath the door of a 3 8 gap. Step 3 tighten the hinge clamp. Close the shower door.