Install the kickout flashing underneath the first shingle photo 1.
Add flashing around replacement window where siding has been removed.
Tape the flap from step 2 over the flashing.
Extract nails keeping the vinyl pieces in place in order to prepare vinyl pieces to be removed.
Secure the wrap to the flange with tape or caulk.
Install side flashing over the wrap.
Use a siding removal tool.
Use this tool by inserting it where a piece of vinyl overlaps a piece below it and then sliding it across until you reach the end of.
Install head flashing and extend out 3 4 inch to each side.
Because of this you have many options for how you install the tile around it.
If possible you can simply remount the.
Next apply strips of 4 in.
How to install flashing around a window when you install a window in new construction the building wrap overlaps the self adhesive flashing.
Add building paper which should extend behind the window s nailing fin.
In a remodeling job apply self adhesive flashing strips in this order.
To allow moisture to escape the bottom of the window is not flashed.
Because the vinyl siding on the exterior of the window does not provide a 100 waterproof barrier it s important to also install building paper and flashing to avoid water getting in and rotting the wood beneath the window.
If you re siding right against the window.
Once the siding has been removed you will need to inspect the paper and flashing behind it to ensure that it has not suffered any water damage.
After you have placed the flashing and waterproofing you will need to butt the siding up to the edges of the window.
On both sides of the window or door trim the wrap close to the window or door flange.
Add felt if needed before nailing the new wood on and prime the new wood on all four sides before installing it.
This isn t so critical if the water from the shower will not be spraying on the window.
Flashing tape over the exposed face of the installed strips sticky side to sticky side and also to the sheathing.
If the shingle already has flashing on it the kickout flashing has to slip beneath it and you ll have to loosen or remove siding to do this.
Along the bottom then the sides then the top.
Also make sure that the flashing along all sides of the window is adequate.
Do not cut the vinyl off.
But if you plan to surround the window with trim choose 9 in wide flashing to protect behind the seam between the trim and the siding.
Then add small pieces of flashing over the gaps at the corners.
Remove the pieces of vinyl siding from around the window area.
Once the flashing has been addressed the tile around the window is mostly cosmetic but does act as an additional physical barrier.
Install the siding around the window.
